Center Consoles

This exciting 2023 Pursuit S 268 features timeless styling, luxury finishes, and modern amenities that Pursuit is known for. Foldaway seating in the cockpit can quickly transform the area from a social zone to fish-ready with port and starboard fishboxes, livewell, and plenty of room for both your crew and your gear. Take the helm and discover the ease of operation and ergonomically-designed controls that make the S 268 a pleasure to run. With an LOA of 27' 4", twin Yamaha® engines, with only 149 hours, and an oversized sport-style hardtop, this boat is going to take you places. Remaining Yamaha engine warranty until 06/20/2026 with the option to extend. Plus includes a custom Load Rite trailer.

• Hull and Deck Joint Mechanically Fastened
• Rub Rail: High Density PVC with Solid 316L Stainless Steel Insert
• Molded One Piece Deck and Cockpit Liner with Non-Skid Pattern Area
• Flush Mounted Integral Anchor Locker with Fiberglass Lid
• Anchor Roller Chute/8" Cleat, 14lb Galvanized Plow Style Anchor and Rode (150' of 1/2" 8 Plait including 10' of ¼" G4 Chain)
• Cleats, 316 Stainless Steel, 8" Pop Up (2) Stern, (2) Spring and (2) Bow
• Molded Recessed Hatches with Gaskets and 316L Stainless Steel Latches and Overboard Drain Tracks
• Molded Transom Walkthrough with Hinged Transom Door, 316L Stainless Steel Latch and Positive Catch
• Self-Draining Cockpit with Bronze Ball Valve at Hull Side
• Bow Grab Rails, 316L Stainless Steel (Port & Starboard)
• Transom Grab Rail, 316L Stainless Steel, (Port)
• Navigation Lights, LED, 2 Mile

• Rod Holders (6), Stainless Steel, (4) in Gunwale and (2) in Helm Seat Module
• Lighted Oceana Blue 28 Gallon Recirculating Insulated Livewell with Acrylic Lid
• Under Gunwale Rod Storage (4) with Reel Pads (Port and Starboard)
• Fish Boxes (28 gallons each), In-Floor, Insulated and Diaphragm Pump with Overboard Discharge (Port and Starboard)
• Vertical Rod Holders (5), Stainless Steel, in Transom
• Dedicated Tackle Storage Trays (5) and Drawers (2)
• Bait Prep Cutting Board

• Molded Fiberglass Hardtop
• Powder Coated Structural Hardtop Supports with Grab Rails
• Overhead Storage Box
• Four (4) Rod Holders
• Custom Stainless Steel Ratcheting Anchor/Stern Light with Burgee Rings and USA Flag
• Two (2) Tri Color LED Lights
• Fore and Aft Facing LED Spreader Lights
• Removable Stamoid® with Makrolon® Windscreen (3-piece)
• Dedicated Locations for Radar, Outriggers, VHF and FM Antennas

• Molded Fiberglass Aft Tilting Helm with Instrumentation Visor, Electronics Mounting Surface and Fixed Fiberglass Footrest 
• 316L Stainless Steel Steering Wheel on Sport Tilt Plus Helm
• 12V Panel with Illuminated Carling® Rocker Switches
• 316L Stainless Steel Helm Drink Holders (2) 
• Compass
• Trim Tab Control Panel and Indicator
• 12V Outlet and Dual USB Charger
• Fire Extinguisher (Under Port Gunwale)

• Two Piece Fiberglass Door with Gasket and 316 Stainless Steel Automotive-Style Locking Latch
• Molded Fiberglass Interior 
• Console Entry Steps 
• Manual Porcelain (Freshwater) Head with 6 Gallon Holding Tank, Macerator Discharge Pump, 316L Stainless Steel Deck Pump-out Fitting and Bronze Thru Hull Fitting with Seacock
• Vanity with Stainless Steel Sink and Freshwater Faucet
• Access to Fresh Water Pump with Filter
• Vanity Mirror
• Integrally Switched 12V Overhead Light
• Storage Hooks (3)
• Dedicated Towel Storage Areas (2)
• Toilet Tissue Holder 
• Fire Extinguisher

• UL® Rated Fully Tinned, Color Coded Copper Wire
• Custom In-House Built, Heat Sealed, Mechanically Crimped, Color Coded Battery Cables
• Custom In-House Built, One-Piece Electrical Harness with Waterproof Connectors and Chafe Protection
• Powder Coated, Aluminum, Screen Printed (Front and Back) Battery Switch and Breaker Panel
• Bonding System: Thru Hull Fittings Below Water Line, Trim Tabs, Zinc Anode and Garboard Drain
• Two Battery System: Port Engine (1) and Starboard Engine/House (1) 
• Grounding Bus Bar
• Electronics Fuse Block
• 12V Outlet and Dual USB Charger

• Molded Interior White Gel Coat
• Molded Hatch with Gasket and Stainless Steel Gas Spring
• Molded Bilge Sump Area
• Two (2) 1500 GPH Bilge Pumps with Electronic Switches and Stainless Steel Clad Thru Hull Fittings
• 1100 GPH Tournament Series Livewell Pump, Seacock and Thru Hull Fitting
• Pressure Sensing Raw Water Pump with In-Line Filter
• Fish Box Diaphragm Evacuation Pump with Selection Valves

• EPA Compliant Lined 139 Gallon Rotomolded Fuel Tank with Engine Pickups, Shutoff Valves, Digital Level Indicator and Deck Fuel Fill Plate
• Custom Built Premium Fuel Feed Lines with Mechanically Crimped Fittings
• Two (2) Yamaha® Water Separating Fuel Filters with Primer Bulbs

• 20 Gallon Water Tank and 316L Stainless Steel Deck Fill Plate
• Premium Sea Tech Color Coded Water Hose System with Mechanically Crimped Ends
• Pressure Sensing/Variable Speed Water Pump with In-Line Filter
• Faucet in the Head
• Cockpit Shower with Hose